Setting up a Brick Paver Walkway or Plaster Brick Wall

The usage of Bricks or Pavers to produce a walkway or patio area complements a house in a method that is unmatched. In addition, installing a Brick or Paver walkway does not necessarily need a pro.

The secret to installing a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be set up. The location must be removed at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines ought to be strung on each side of the sidewalk. The string lines suggest the completed height of the sidewalk.
Once the location has actually been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. The height between the tamped down sand and the stringline must equal the thickness of the brick or paver.

Now that you have a steady base, position a 1" pipe or ledger board the length of the sidewalk on either side of the walkway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your walkway border and help to maintain the integrity and shape of the walkway.

You can then begin to lay the bricks/pavers once here this is done. There are many patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the integrity of the walkway.

Inevitably bricks/pavers will need to be cut or divided when constructing the sidewalk. Unless you desire to buy or lease a pricey wetsaw, I would suggest acquiring an easy brick/paver splitter. It is essentially a chisel with a large end that is the width of the bricks/pavers. To actually cut/split click here the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Utilizing a hammer strike the butt end of the chisel firmly. You might require to do this a number of times. You might also wish to flip the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver must break cleanly. If your walkway has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop the outdoors edges with additional sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the new walkway and sweep into the cracks. This will complete the interlocking of the bricks and help to get rid of any weed growth.


In addition, installing a Brick or Paver walkway does not necessarily require a pro. The key to installing a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, put a 1" pipeline or journal board the length of the pathway on either side of the sidewalk. These strips will act as your pathway border and assistance to preserve the integrity and shape of the walkway. Undoubtedly bricks/pavers will require to be cut or divided when developing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *